HARVEY Axminster Trade AT220TSM, Руководство пользователя, Страница: 22 / 48

- 20 -
6.3 Cross-Cut Fence
Square to Fence:
1. The crosscut fence or miter fence must be set 90 degree to the fence of the guard. Cut a
1000x1000mm MDF or similar material with the thickness of at least 15mm by 5 times. (Put the
last cutting side against the fence for the next cut, keep turning the testing piece in same
direction). Measure the width differences between the 5
th
cut and the 3
rd
cut at both ends. The
difference should be less than 0.75mm, see
Fig.28
Fig.28
Adjust as Follow
：
(
Fig.29
)
1. Loosen the knob (D), (E), and the nut (A).
2. Turn the screw (B) in or out
3. Push the fence and make the block (C) is against screw (B). Tighten the nut (A).
4. Secure the fence to the cross-cut table
5. Repeat step 1.
Fig.29 Fig.30
Adjustment of the Crosscut Fence Scale:
For the first time to use the fence or replace the cutter, the scale must be re-adjusted:
Set the stop plate (H)
(Fig.30 )
at a certain location and cut a piece of workpiece.
a. Measure the length of the workpiece, release the little knob (I)
( Fig.30 )
under the fence, adjust
the location of the scale to fit the length you measured, confirm the scale’s location and lock the
scale by turning the knob (I)
。
b. Adjust the inner scale by the same way as above.