Harsco Industrial MODU-FIRE FORCED DRAFT N750, Инструкция по установке и эксплуатации

Страница: 39 / 54

MODU-FIRE® Forced Draft Gas-Fired Boiler
39
5.7 M
ANUAL
R
ESET
E
RROR
C
ODES
– A##
Code ENVI Display Lockout Description
A00 NED Unassigned No Error Description, Call For Service
A01 IGNITION FAILURE Ignition Failure During an attempt to light, no flame was detected
A02 FLAME FAILURE Flame Failure During run, the flame was lost
A03 HIGH LIMIT High Limit
The temperature in the boiler exceeded the setting on
the High Limit Control
A05 INT ERR GAS VLV RLY Internal Error Gas Valve Relay Call for service.
A06 INT ERR SAFETY RLY Internal Error Safety Relay Call for service.
A07 LOW FLOW / ILK
Low Water Flow or Open Inter-
lock Jumper (ILK)
Water Flow is Inadequate or
Interlock Jumper (ILK) is Open
A09
INTERAL ERROR
9 or 27 or 28 or 29 or 30
Internal Error
9 or 27 or 28 or 29 or 30
Call for service.
A10 INT ERR E2PROM ERR Internal Error E2PROM Err Call for service.
A12 INT ERR E2PROM SIG Internal Error E2PROM Sig Call for service.
A13 INTERAL ERROR 13 Internal Error 13 Call for service.
A14 INTERAL ERROR 14 Internal Error 14 Call for service.
A15 INTERAL ERROR 16 Internal Error 16 Call for service.
A16 INTERAL ERROR 22 Internal Error 22 Call for service.
A18 INTERAL ERROR 19 Internal Error 19 Call for service.
A19 LATE FLAME Late Flame
Flame still present after boiler gas valve closed during
post purge
A20 EARLY FLAME Early Flame
Flame detected before boiler gas valve opened during
pre purge
A30 HIGH GAS PRESSURE High Gas Pressure Error
The gas pressure is too high and has tripped the
HGPS
A31 LOW GAS PRESSURE Low Gas Pressure Error The gas pressure is too low and has tripped the LGPS
A32 INTERAL ERROR 23 Internal Error 23 Call for service.
A33 FAN WRONG SPEED Wrong Fan Speed Error
Fan deviation more than 300 rpm for > 1 sec (ignored
when fan > 4200 rpm)
A34 AIR SWITCH NOT OPEN Air Switch Not Open Air switch does not open when fan is off
A35 AIR SWITCH NOT
CLOSE
Air Switch Not Closed Air switch does not close when fan is running
A37 UV SENSOR DEFECT UV Sensor Defective
Self Check function of UV detector has indicated a
failure
A38 MAX DT EXCEEDED Max Delta Temp Exceeded
Maximum temperature differential across the boiler has
been exceeded
A39 RAPID RISE INLET TMP Rapid Rise Inlet Error Inlet temperature is rising too rapidly
A40 RAPID RISE OUT TEMP Rapid Rise Outlet Error Outlet temperature is rising too rapidly
A41 RAPID RISE HX TEMP Rapid Rise HX Temp
Temperature across heat exchanger is rising faster
than allowed
A43 LOW WATER LEVEL Low Water Cutoff Water is too low for boiler to operate
A45 INTERNAL ERROR 31 Internal Error 31 Call for service.
NOTICE! When an Internal Error occurs, as identified above, the failure is internal to the ENVI™ boiler
control and replacement of the ENVI™ control is required. A qualified service technician must replace
the ENVI™ control.