Harris FR6822+, Инструкция по установке и эксплуатации

Страница: 78 / 128

Chapter 4
FR6822
+
QXFE Configuration, Monitoring, and Control
64
Copyright © 2008-2011, Harris Corporation
Configuring SNMP Agent and System Settings
The SNMP Agent settings are the same whether you are configuring SNMP using the HTTP
control interface or CCS Navigator.
Below the SNMP Agent settings are System settings. The Description , Location ,
Contact , and Name information in these fields is normally defined by an administrator, and
describes the 6800
+
ETH card that is currently selected. This information is available on the
6800
+
ETH card when it is retrieved by a MIB browser.
The Trap Destination IP Addresses field contains a list of IP addresses that will receive
SNMP traps. It is in the format IP Address:Port Address:SNMP version.
Configuring SNMP Settings in CCS Software
You can use CCS Navigator, in Build mode, to configure SNMP. Follow these steps:
1 If the FR6822
+
QXFE frame and its modules have not been discovered, perform the
Discovery operation, and then save the results of the discovery.
See Discovering Frames and Modules Using a CCS Application on page 32 for more
information.
Note: Information about discovering modules can also be found in your CCS software
application manual or online help. (If you cannot discover the device, see Manually
Adding a Device to the Discovery or Network Folder on page 41.)
2 Right click on your 6800
+
ETH module in the Navigation pane (normally on the left side of
the screen), and then choose Configuration from the drop-down menu.
The Configuration dialog box appears.
3 Choose the SNMP tab, and then click Read .
Navigator polls the 6800
+
ETH card and retrieves its current settings. It fills in all the fields on
the SNMP tab of the Configuration dialog box with the settings that are on the module.
Table 4-3 SNMP Agent Fields of SNMP Tab
Field Function
Port Number (Can be from 0 to 65535) The network port used by
the SNMP agent; Port 161 is the default for
6800
+
ETH
Read Community Has to match the “read community” setting in your
MIB browser
Write Community Has to match the “write community” setting in your
MIB browser
Enable Authentication
Traps When checked, authentication traps are sent if the
read or write community doesn’t match between the
SNMP agent and MIB browser
Enable SNMP Agent When checked, SNMP support is available; if not
checked, SNMP support is disabled