Harris FR6822+, Инструкция по установке и эксплуатации

Страница: 101 / 128

87
Copyright © 2008-2011, Harris Corporation
B
Troubleshooting
Ethernet Network or FR6822
+
QXFE Frame Failure
Before contacting a Customer Service representative to resolve a technical issue, do the
following:
1 Ensure the 6800
+
ETH module is connected with the proper Ethernet cable.
Use a normal cable for connecting to a hub or switch; use a crossover cable for a direct
connection to a PC.
2 Ensure that the coaxial loop is properly terminated with a 75

BNC terminator on
connected frames.
Discovering, Controlling, and Monitoring Devices
If Navigator does not discover some or all 6800
+
devices, ensure the following:

The PC is a single processor

IP address settings for the PC and the 6800
+
ETH module are on the same subnet (the IP
addresses are all within a similar range; for example, 192.168.100.250 and
192.168.100.245)

The FR6822
+
QXFE frame is turned on last and is given 3 to 4 minutes to initialize

All front modules are securely plugged in (including the resource module on the left side
of the frame) and all back modules are installed and seated correctly

All front modules match the corresponding back connectors

All 6800 series modules are compatible (see Using 6800 Series Modules in FR6822
+
Frames on page 89)
For specific troubleshooting tips on discovering the 6800
+
ETH module, see Pinging an
Installed 6800
+
ETH Module on page 88.
Resetting the 6800
+
ETH IP Address
If you do not know the IP address of an 6800
+
ETH module, you can set it back to the
default, and then set it to a new IP address. Follow these steps:
1 Remove the 6800
+
ETH module from the frame, following the steps in Removing a
Resource Module on page 15.
2 Locate the DIP switches on the 6800
+
ETH module.