Harris ACS-163, Руководство по установке и эксплуатации

Страница: 137 / 178

5 – Remote Control ACS-160 Series & STL-160 Series T1 Multiplexer Installation & Operation
Version 2.11, August 2011
Harris Corporation 5-39
Intraplex Products
5.2.3.8 CONFIG? Responses – Channel Module Alarms
The channel module alarm mask setting is reported in the ISiCL CONFIG? Response, which is in this
format:
CH-ALM= <Active Subaddress Alarms>
Channel modules alarms are user-maskable through ISiCL, allowing you to configure the multiplexer
so that only program audio channel modules can generate shelf alarms. Check your channel module’s
documentation to determine if it supports alarm masking. Table 5-18 gives the syntax for channel
module alarm masking.
Note: If a channel module is masked off and it fails, it generates a shelf alert.
Table 5-18. ISiCL Syntax for Channel Module Alarm Masking
Parameter
Legal
Values Description
CH-ALM ALL,
NONE,
1 to 36 Select alarms from the channel module sub-addresses that are OR’d onto the
shelf alarm.
If “ALL” is entered, all sub-addresses reporting an alarm condition are totaled
onto the shelf alarm using a logical OR function.
If “NONE” is entered, no sub-addresses reporting an alarm condition are totaled
onto the shelf alarm using a logical OR function.
If a number 1-36 is entered, that sub-address is totaled onto the shelf alarm
using a logical OR function. Any subsequent sub-address number is also be
totaled using a logical OR function. For example, if the ISiCL commands:
::SET:CH-ALM=NONE;
::SET:CH-ALM=1;
::SET:CH-ALM=2;
and entered, alarms for channel modules on sub-address 1 and 2 are totaled
onto the shelf alarm using a logical OR function.
ALL is the factory default.
5.2.3.9 Line/Module Redundancy ISiCL CONFIG? Message
The ISiCL “CONFIG?” message has been changed to support the added ISiCL “SET” parameters. All
new SET parameters are added to the CONFIG? message response, as in this example:
:BTERM:CONFIG?:;
<CR>
*OK
PTIME = INT (PRIMARY TIMING)
FTIME = INT (FALLBACK TIMING)
CH-ALM = ALL
FRAMING = ESF
CODE = B8ZS
MRDN=RVRT
MLINE=SAME
LRDN=RVRT
LSDLY=1S
LRDLY=10S
LOS=ON
OOF=ON
AIS=ON
UAS=ON
YEL/RA=ON
BER=10E-3;