Harmopool Harmo PAC Series, Инструкция по эксплуатации

Страница: 5 / 19

5
Installation
Accessories needed for the installation
The factory only provides the heat pump. Other necessary items that could be mentioned in the illustrations are to
be provided by the user or installer.
Attention! Please follow the following steps when installing the heat pump:
○ The chemicals have to be added downstream of the heat pump.
○ It is recommended to install a bypass when the flow of the pool pump is more than 20% of the rated flow of
heat exchanger from the heat pump.
○ Install the heat pump on a solid foundation and use rubber below the heat pump to eliminate vibrations and
noise.
○ Installeer de warmtepomp op een solide basis en gebruik de dempende rubber om het geluid en de vibratie te
elimineren.
○ Keep the unit straight up at all times. When the unit has been tilted, it is required to wait 24 hours before re-
starting the heat pump.
○ The heat pump can be installed practically anywhere outdoors. If you wish to install it indoors, please contact
your supplier.
Location
The heat pump can be installed practically anywhere outdoors.
DO NOT place the unit in a closed area with a limited air volume where the air discharged by the heat pump
will be re-circulated
DO NOT
put the unit next to bushes. This can block the air inlet. Such locations deny a continuous source of
fresh air, which reduces the efficiency of the heat pump and can prevent adequate heat delivery. The picture
below shows the minimum required distances from each side of the heat pump.