Replacing a SAS card
c. Press gently on the back of the riser assembly first, then the front, until both edge connectors are
firmly seated in their riser slots.
IMPORTANT:
If the edge connectors are not aligned properly, lift up the assembly
and attempt to install it again. Do not rock the riser assembly into position. Doing so
may damage the contact pins within the riser slot.
d. Reconnect the internal cable to the front of the LTC card.
Installing the system cover
The server system must be operated with the system cover in place to ensure proper cooling.
1. Place the system cover onto the chassis and slide forward until the front edge of the system cover is
pressed up against the back edge of the front drive bay.
2. Hand tighten the two captive thumb screws at the back of the chassis.
3. Using a screwdriver, install the top cover screw(s).
Example:
31
MediaDirector Component Replacement Guide
