Harmar Mobility AL215 Axis I, Инструкция по установке и эксплуатации

Страница: 17 / 44

Inside Lifts - Installation & Owner’s Manual TEC0091 2016JUN30 P/N: 630-00076-Rev A
|
| www.harmar.com | 800-833-0478
© 2016 Harmar All Rights Reserved
15
INSTALLER
VEHICLE’s THRESHOLD
USED FOR S
EAT
ATTACHMENT
POINT
TELESC
OPING
LEG
SWIVEL
LEG
VEHICLE’s
THRESHOLD
LL
A
W
s’
EL
CI
H
E
V
CHOOSE
HOLE FOR
CLOSEST
TO WALL
POSITION
1" or 2”
OBTAIN
DISTANCE
Fold up third
row seating
Figure 15-1
PLAC
E ON
WELL
FLOO
R
THRESHOLD
Figure 15-2
INSTALLATION
WASHERS
Drill two 3/8" holes
through back well
wall using joiners
as template to
accept fully
threaded
3/8" bolts.
Figure 15-3
Figure 15-4 Figure 15-5 Figure 15-6
BASE INSTALLATION:
3
RD
ROW FOLDING SEATS
1. Place vertical joiners on back wall of seating
well corner. [Figure 15-1] Use base as template for
position.
2. Establish height by having mounting holes
show over threshhold. [Figure 15-2] Attach joiners,
using small screws provided, to lock height.
3. Preferred Installation. Mandatory when lifting
heavier payloads.
• Drill two 3/8” holes in floor of well using
joiners as template. Fasten 3/8” hardware
(x2).
[Figure 15-3]
• PLUS Drill two 3/8” holes through back well
wall using joiners as template to accept full-
threaded 3/8” bolts.
VERIFY THAT ALL MATING SURFACES ARE FLUSH.
4. Fold third-row seating back into well. Verify
vertical joiner mount holes are above threshold.
[Figure 15-4]
5. Attach vertical joiners to base using supplied
hardware as indicated. [Figure 15-5]
6. Insert telescoping leg.
Attach swivel leg. Drill,
or where possible, use J-hook to seat attachment
point and secure leg.
[Figure 15-6]
Tighten all fasteners.
INSTALLATION