Harmar Mobility AL215 Axis I, Инструкция по установке и эксплуатации

Страница: 19 / 44

Inside Lifts - Installation & Owner’s Manual TEC0091 2016JUN30 P/N: 630-00076-Rev A
|
| www.harmar.com | 800-833-0478
© 2016 Harmar All Rights Reserved
17
INSTALLER
OR
Driver's Side Base
Passenger's Side Base
Figure 17-1
Figure 17-3
Long Leg Extension
(AL207)
Standard
Leg
Extension
Figure 17-2
BASE INSTALLATION:
TRUCK BED
1. Place base in corner of truck bed. Attempt to
position as close to the corner as possible while
leaving at least 1” clear around the base on all
sides.
[Figure 17-1]
2. Install leg extensions
into base tubes and
extend them as far as they will go. The Long Leg
Extension should run parallel with the bumper.
Set screws can be hand-tightened at this time.
[Figure 17-2]
3. Recommended practice before drilling.
With base in position, use a tape measure to
estimate the distance in both directions from an
exterior reference point (Ex. outside body panel)
to all three potential bolt holes. Repeat this
underneath the truck bed.
[Figure 17-3]
Check framing, bracing, or other nearby
thickened structure on which to mount the
lift. Adjust position of base and leg extensions
to capture as much frame as possible while
avoiding the vehicle’s gas tank, spare tire,
suspension components etc.
CAUTION!
USE EXTREME CAUTION!
Examine
area for obstructions or potential
hazards such as gas tank and fuel /
brake / electrical lines.
INSTALLATION