Harman XXV Pellet Stove, Инструкция по установке и эксплуатации

Страница: 6 / 44

6
XXV Pellet Stove
cautiOn
hOt while in OPeratiOn. keeP children,
clOthing and Furniture awaY. cOntact MaY
cauSe Skin burnS.
dO nOt inStall a Flue daMPer in the
eXhauSt Venting SYSteM OF thiS unit.
dO nOt cOnnect thiS unit tO a chiMneY
Flue SerVing anOther aPPliance.
cautiOn
keeP cOMbuStible MaterialS (Such
aS graSS, leaVeS, etc.) at leaSt 3
Feet awaY FrOM the Flue Outlet On
the OutSide OF the building.
iMPOrtant nOteS
Flame guide
Install the cast
iron flame guide
on top of the burn
pot. Make sure that
the flame guide is
fully seated on the
vertical sides of the
burn pot and that the
back of the guide
rests against the
burn pot mounting
flange.
Figure 1
The power cord is tucked inside the left rear cover panel.
To remove cord, Loosen the two 5/16" hex heads and
slide the panel outward.
assembly and installation
due to high temperatures, the stove should be
placed out of traffic and away from furniture and
draperies.
children and adults should be alerted to the
hazards of high surface temperatures and should
stay away to avoid burns to skin and/or clothing.
Young children should be carefully supervised
when they are in the same room as the stove.
clothing and other flammable materials should
not be placed on or near this unit.
installation and repair of this harman stove
should be done by a qualified service person. we
recommend that the stove be inspected before use
and at least annually by a qualified service person.
Periodic cleaning is required throughout the heating
season and at the end of each winter for the stove
to work efficiently. See cleaning instructions.
Fuel should be stored in a cool dry place, well
away from the room heater. do not store fuel within
the installation clearance area or the space required
for loading and/or ash removal.
dO nOt uSe MakeShiFt PartS Or Other
cOMPrOMiSeS when inStalling thiS
aPPliance.
cautiOn: dO nOt cOnnect tO anY air
diStributiOn duct Or SYSteM.
warning
keeP Viewing and aSh reMOVal dOOrS and
hOPPer lid tightlY clOSed during OPeratiOn.
dO nOt burn garbage Or FlaMMable
FluidS Such aS gaSOline, naPtha Or
engine Oil.
install the venting only at the clearances
specified by the venting manufacturer. Some
brands of pellet venting require a 3" clearance
to combustibles, while other brands may require
only one inch.