19
XXV Pellet Stove
autOMatic ignitiOn/OPeratiOn
Fig. 21
This setting, see above, will produce continuous maximum heat
output with the distribution blower at full speed.
Stove temperature Mode
This setting, see above, will produce continuous medium heat
output with the distribution blower at low speed.
Stove temperature Mode
In the Stove Temperature Mode and with the igniter
toggle switch in the Auto position, the stove will light
automatically and can be adjusted to the desired setting
using the same temperature control dial as is used in
the Room Temperature Mode. The heat output and fuel
consumption will remain constant regardless of room
temperature. The settings from 1 to 7 on the inner ring
of the dial provide for relative heat output settings with
1 being low and 7 being the maximum.
In Stove Temperature Mode, the stove will not
automatically shut off unless the stove runs out of fuel
or is turned off.
Never disconnect the power cord to shut down the
stove. This will stop the combustion blower and smoke
will escape through window and door gaskets.
Feed adjuster knob
This knob controls the maximum amount of time per
cycle that the feed motor is allowed to run. Based on the
control settings and temperature demand, the control
will make it's own determination of how long to run the
feed motor,
uP tO
the maximum allowed by the Feed
Adjuster knob setting. For most premium grade pellet
fuels, the feed adjuster should be set at #4. If high-ash
fuel is used, the setting may need to be adjusted to #5
or 6. Higher settings are also needed if you want to
achieve the maximum capacity of the stove. Just be
sure that when burning at maximum, Stove temperature
mode with the feed adjuster on #6 and the temperature
knob on "7" or "90°", the pellets are not falling off of the
front of the burn pot before they have a chance to burn
completely. You should try to keep about one inch of
ash in front of the burning pellets.
Shut down Procedure
The best way to shut down the stove is to simply let it
run out of pellets, the stove will shut down automatically.
Alternatively, you can turn the Mode Selector to “off”.
This will cause the fire to gradually die down and go
out. The fire will not go out immediately and may take
more than an hour to fully shut down.
If the stove is left to run out of fuel, you may get a
6 blink status light. If this happens simply reset the
control board by turning the mode selector to OFF and
back ON.
Содержание XXV Pellet Stove
