Harman Martin Exterior Wash 200 Series, Руководство пользователя

Страница: 23 / 40

Martin
®
Exterior Wash
TM
200 Series User Manual 23
To set the fixture’s dimmer curve:
1. Access the control menu and select FIXTURE CONFIG. Press ENTER.
2. Select DIMMER CURVE and press ENTER.
3. Select the option desired from the list above and press ENTER.
Effects speed
You can change the speed at which the fixture changes from one effect to the next. This lets you optimize
effect changes for either smoothness or speed.
To set the speed of effect changes:
1. Access the control menu and select FIXTURE CONFIG. Press ENTER.
2. Select EFFECT SPEED and press ENTER.
3. Select SLOW to obtain the smoothest changes or FAST to obtain the fastest changes.
4. Press ENTER.
White balance
White balance can be modified on 200 and 210 models by adjusting the amount of each color that is
added to the mix to make white.
1. Access the control menu and select FIXTURE CONFIG. Press ENTER.
2. Select WHITE BALANCE and press ENTER.
3. Select a color to adjust and press ENTER.
4. Press UP or DOWN to increase or decrease the amount of that color in the white balance mix. Press
ENTER.
5. Repeat steps 3 and 4 for the other two colors.
DMX State – behavior when no DMX or Host signal is received
There are three options for setting how a fixture behaves when it is offline, i.e. when it is not receiving a
control signal from either a DMX controller or a host fixture:
SHOW MODE: Fixture executes its standalone show (fixture must be set to HOST).
If the fixture is set to HOST and it does not receive a control signal, the fixture will execute the scenes
in its pre-programmed standalone show (see ‘Programming a standalone show’ on page 20). It will
also send a signal to any fixtures that are connected to it and set to CLIENT instructing them to run
their standalone shows.
If the fixture is set to CLIENT and it does not receive a control signal, it will black out until it receives a
control signal.
HOLD LAST LOOK: Fixture holds and displays the last received DMX command (fixture must be set to
HOST).
If the fixture is set to HOST and it does not receive a control signal, it will continue to obey the last
DMX command that it received.
If the fixture is set to CLIENT and it does not receive a control signal, it will black out until it receives a
control signal.
BLACK OUT (default): Fixture blacks out.
If the fixture is set to HOST and it does not receive a control signal, it will black out until it receives a
control signal.
If the fixture is set to CLIENT, it will always black out if it does not receive a control signal.
These options also apply if a fixture is receiving a control signal but that signal is suddenly lost.
To set a fixture’s offline behavior:
1. Access the control menu and scroll to FIXTURE CONFIG. Press ENTER.