Harman Martin DMX PowerPort 375 Series, Руководство пользователя

Страница: 10 / 24

10
DMX PowerPort 375™ User Manual
Wall mounting
To install a DMX PowerPort 375 on a wall or similar flat,
stable mounting surface:
1. Check that there will be free airflow and at least
100 mm (4 in.) of clearance around the unit.
2. Using eight of the supplied screws, fasten the supplied
short rack mounting ears to the sides of the DMX
PowerPort 375 as shown in Figure 4.
3. Using bolts or screws that are suitable for the weight
of the unit, the mounting surface and the environment,
fasten the mounting ears of the DMX PowerPort 375
to the mounting surface. Check that the unit is held
securely.
Truss mounting
To fly a DMX PowerPort 375
unit from a rigging truss
using a rigging clamp:
1. Check that there will be
free airflow and at least
100 mm (4 in.) of
clearance around the
unit.
2. Obtain a rigging clamp
and a safety cable that
are suitable for the
weight of the unit, all
connected cables, etc.
Suitable items are
available from Martin
(see “Accessories” on
page 18).
3. See Figure 5. Using two
of the supplied screws,
fasten the supplied
safety cable attachment
bracket to one side of the unit.
4. Using an M10 bolt with a maximum length of 20 mm (0.8 in.), fasten the rigging clamp into the side of the
unit.
Important! The bolt must not protrude more than 20mm into the unit, or it may damage the
internal electronics.
Important ! La vis ne doit pas dépasser de plus de 20 mm dans l'appareil au risque
d'endommager l'électronique interne.
5. Hook the rigging clamp over the truss chord and fasten it.
6. Loop the safety cable around the truss and fasten it to the safety cable attachment bracket so that the
safety cable will catch the unit if the rigging clamp fails. Check that the unit is held securely.
Figure 4: Setup for wall mounting
Figure 5: Setup for truss mounting