39
• You can set the distance within the range of 0.1 ~ 9.0
meters in 0.1 meter intervals .
3.
Press the
◀
/
▶
buttons to set the selected speaker according to your distance to it.
4.
Repeat the above steps 2 and 3 until the distances are all set as desired.
�
About the speaker distance
When enjoying multi-channel surround playback with Dolby Digital and DTS sources, etc., it is ideal that the center and surround
speakers should be the same distance from the main listening position as the front speakers. By entering the distance between
the listening position and each speaker, the delay times of center and surround speakers are automatically adjusted to create an
ideal listening environment virtually as if the center and surround speakers were at their ideal locations respectively.
• You can adjust the crossover frequency within the
range of 40 ~ 200 Hz in 10 Hz intervals.
When selecting the CROSSOVER
�
About the crossover frequency
• When speakers are set to "S (Small)", low frequencies in those channels that are below the crossover frequency are output
from subwoofer or front speakers which are set to "L (Large)" (when not using a subwoofer).
• Refer to the operating instructions of the speakers to be connected. If the frequency range of your speaker is 100 Hz~20 kHz,
the crossover frequency should be set to 100 Hz(or slightly higher).
• When speakers are set to "S (Small)", be sure to set their crossover frequency correctly according to their frequency
characteristics.
1.
Press the
▲
/
▼
buttons to select the "X-OVER", then
press the OK button.
2.
Press the
◀
/
▶
buttons to set the crossover frequency
as desired.
ENGLISH
AVR-134 2008.12.1 10:31 AM 페이지 39
