ENGLISH
• Depending on your speaker type, you can select one of these following
speaker types.
L(Large): Select this when connecting speakers that can fully reproduce
sounds below crossover frequency.
S(Small) : Select this when connecting speakers that can not fully reproduce
sounds below crossover frequency. When this is selected, sounds
below crossover frequency are sent to the subwoofer or speakers
which are set to "L (Large)" (when not using a subwoofer)
N(None): Select this when no speakers are connected. When this is selected,
sounds are sent to the speakers which are not set to "N (None)".
Y(Yes)/N(No): Select the proper setting, depending on whether a subwoofer
is connected or not.
NOTES :
• When speakers are set to "S (Small)", you should set their crossover frequency correctly according to their frequency
characteristics. (For details, refer to "When selecting the CROSSOVER" on page 39.)
• When "SUB-W" is set to "N (No)", "FRONT" is automatically set to "L (Large)".
• When the "FRONT" is set to "S (Small)", "CENTER" and "SURR" cannot be set to "L (Large)".
38
3.
Press the
◀
/
▶
buttons to set the selected speaker as desired.
4.
Repeat the above steps 2 and 3 until the speakers are all set to the desired mode.
�
About speaker size
• Select "L (Large)" or "S (Small)" not according to the actual size of the speaker but according to the speaker's capacity for
playing low frequency (bass sound below frequency set on the "X-OVER" menu) signals.
• If you do not know, try comparing the sound at both settings (setting the volume to a level low enough so as not to damage
the speakers) to determine the proper setting.
When selecting the DISTANCE
1.
Press the
▲
/
▼
buttons to select the DISTANCE, then
press the OK button.
NOTE :
You cannot select the speakers set to "N (None
or No)".
2.
Press the
▲
/
▼
buttons to select the desired speaker.
AVR-134 2008.12.1 10:31 AM 페이지 38
