Harman Home Heating Harman Accentra Insert, Инструкция по установке и эксплуатации

Страница: 8 / 48

8
ESP Control
Status light error messages:
3 Blinks:
Indicates that the ESP (Exhaust Sensing
Probe) has failed, has a broken connection, or has
gone out of range too many times. This requires a
manual reset*.
4 Blinks:
Can occur only in Room Temp Mode and
indicates Room Sensing Probe failed or not installed.
If a Room Sensing Probe is then installed, the status
light will automatically reset.
NOTE: Unit will not start in "AUTO" with this status
error.
5 Blinks (In Igniter Auto. Mode Only): Indicates that
the unit has failed to light within the 36 minute start
cycle. To reset - Turn Mode Selector to "OFF", then turn
to either mode again.)
6 Blinks : Indicates that the control has calculated poor
or incomplete combustion occurring for more than 50
minutes.
A six blink status may be set if the stove is allowed to
run out of pellets. To reset, turn mode selector to "OFF"
then back on to the desired mode. If the unit was not
out of pellets, see Troubleshooting section, Page 33,
for more details.
* manual reset - disconnect power cord for a few seconds
and reconnect. If error still occurs call your Dealer.
Feed adjuster
Sets the maximum
feed rate
Test
Runs all motors at
full speed for one
minute to check
operation. After two
minutes the stove will
go to minimum burn
and the blowers will
alternate from high
to low every minute
to remind you that
you are still in "Test
Mode".
Igniter switch
Set to appropriate
Start-Up mode.
Distribution Blower speed
adjustment range.
L = low
H = high
Variable speed anywhere
b e t w e e n L a n d H ;
although as the stove
temp. goes up , so does
the L and H scale.
Temp dial
Allows you to adjust the room temperature setting, in Room
Temp Mode, using the outer scale marked in degrees
Fahrenheit. It also allows you to adjust the stove temperature
setting, while in Stove Temp Mode, using the inner scale
marked from 1 to 7.
Mode Selector
Allows you to choose
between Room Temp Mode,
Stove Temp Mode, or OFF.
Also allows you to vary the
distribution blower speed by
turning the knob to the high
or low side of each mode.
Power Light
Indicates power to the
control.
Indicates power to the
feed motor.
Indicates igniter is on.
Indicates power to
combustion blower
Status Light
Will be lit in either stove
or room temp mode
when pointer is not
within off position band
except after normal shut
down. Blinks to indicate
errors listed below.
Indicates power to
distribution blower.
Dealer Diagnostic Port
For dealer maintenance
only. Requires special DDM
monitor supplied to Harman
Dealers exclusively.