11
STEP 5
Locate:
Dampers [7], three 10-24x1/2” Screws
[3c], 10-24 Nuts [4c], M5 Spring Washers
[5c] From hardware Pack - Blister card.
Tools needed:
Philips head screwdriver and
3/8” wrench or shifter.
Procedure:
•
From the outside of the cabinet, insert a 10-
24x1/2” Bolt [3c] through the mounting hole for
the damper.
•
From the inside of the smoker cabinet, place
the damper [7] over the vent hole in the back of
the cabinet as shown. The tab on the damper
must mount though the vent hole.
•
From the inside of the cabinet, place the M5
spring washer [5c] on the bolt and tightly thread
the 10-24 nut [4c] onto the bolt.
•
Repeat this process for all three dampers.
•
The damper must be able to rotate with just a
little resistance.
The damper allows adjustment of exhaust
air while cooking. Less exhaust air will allow
for the smoker to burn hotter and keep the
flavouring smoke inside the smoker.
WARNING
THE DAMPER IS DESIGNED SO THAT IT WILL
NOT FULLY CLOSE.
THIS IS A SAFETY FEATURE AND
SHOULD NOT BE ALTERED.
HK0522 2 Door Gas Smoker-Manual_v45.indd 11
15
/
4
/1
9
2:40 pm
