7
C. ASSEMBLY INSTRUCTIONS
1
STEP 1
Locate:
Cabinet (1), lower door (2) and
upper door (3).
Note:
The doors are attached to the cabinet.
Procedure:
•
Remove the doors (2) and (3) from the cabinet
(1) by lifting them straight up on the doors to
remove them from the side cabinet hinge. Set
the doors aside.
•
Turn the cabinet (1) upside down.
STEP 2
Locate:
Four Smoker Legs [6], Eight
1/4-20x1/2” Screw [1a] from the Hardware
Pack - Bag A.
Tools needed:
Philips head screwdriver.
Procedure:
•
Place each leg [6] at the corners of the smoker
Cabinet Assembly [1] as shown.
•
Fasten each leg [6] with two 1/4-20x1/2” Screws
[1a]. The securing nuts are pre-welded to the
cabinet.
Note
: One leg contains an extra hole on its
side and must be mounted at the front in the
position shown. This hole will be used later to
secure the gas hose to the leg with a zip-tie.
Do not yet insert the two screws in the location
indicated for the front legs. These two screws will
be used in the next assembly steps.
Securely tighten six screws.
6
6
1
2
3
Leg with extra hole
Leg with extra hole
WARNING
DO NOT HANDLE SMOKER BY THE CROSS BAR ON SMOKER CABINET.
DO NOT LIFT OR MOVE USING THIS CROSS BAR.
HK0522 2 Door Gas Smoker-Manual_v45.indd 7
15
/
4
/1
9
2:40 pm
