Hardy Process Solutions HI 6110, Руководство пользователя

Страница: 122 / 137

HI 6600 Series Modular Sensor System User Guide
Page | 122
read only parameters are aligned between the output and input tables.
OUTPUT Table Description
Portion of the OUTPUT table used for the Hardy Gateway Module (HGM)
The first four variables in the output table, Command, Aux Command Information, Parameter ID , and
Parameter Value , are used to send commands either the Hardy Gateway Module (HGM) or to a specific
Weight Processing Module, to write new parameter values, read existing parameter values, or read data
values such as COUNT, or ROC, etc.
The
Command is a 32 bit value, with the top 8 bits indicating the channel (WPM) number, the next 8 bits are
reserved, and the bottom 16 bits are used for the command string as shown below.
Bits [31] to[24]
Bits [23] to [16]
Bits [15] to[0]
Channel Number Reserved Command
The 32-bit
Aux Command Information is used for specific information required for special commands.
To select which parameter is being read or written set the predefined number into the Parameter ID; if the
value is being read then the Parameter Value is ignored, or set to the required value if the value is being
written.
Portion of the OUTPUT table used for Weigh Processing Modules (WPMs)
The remaining bytes in the output table are in multiples of 16 bytes, representing 4 variables, for each WPM
in the HI 6600 system.
The first variable Module Reference x is used to select which WPM, (where x = 0 to N) the output table
section is targeting, the next two values Mx Reserved 1 and Mx Reserved 2 are used as padding so the user
selectable read only parameters are aligned between the output and input tables.
The next value Mx
Parameter ID is a user selectable parameter ID values which can be used to return read
only values from the selected WPM. These read only values can be anything from an WPM specific
measurement such as COUNT to a parameter value such as WAVERSAVER.
INPUT Table Description
Portion of the INPUT table used for the Hardy Gateway Module (HGM)
The first four variables in the input table, Command Echo , Command & Gateway Status ,
Parameter ID , and Parameter Value , closely match the first four variables in the output table.
The Command Echo is used to echo the command from the output table, to enable the PAC or
PLC to ensure that the correct command has been executed; and also that command has been
completed and the command status value is valid.
The response of the HGM or WPM to the generic command value or the read only parameter
command value is provided in the
Command and Gateway Status value. The bottom 16 bits are
used for the Command status , and verifies if the command was executed with the expected result;
and the top 16 bits are used for the Gateway Status.