Hardinge Talent 6/45, Руководство по обслуживанию

Страница: 23 / 104

TAILSTOCK LUBRICATION ON TALENT
®
6/45 AND 8/52 LATHES
1. Wait for the cycle to end and that the spindles
and slides are stationary.
- NOTE -
Refer to the Operator’s Manual
(M-447) for information on using Jog
mode to move the tailstock.
2. Move the tailstock toward the guard door
opening to gain access to cover “F”, Figure 2.5.
3. Power down and lock out the machine. Refer to
the appropriate power-down procedure in
Chapter 1.
4. Remove cover “F”, Figure 2.5, to gain access
to the fittings on grease manifold “G”, Figure
2.6.
5. Clean the grease fittings.
- NOTE -
Only use a manually operated grease
gun.
6. Attach the grease gun nozzle to each grease
fitting; slowly and evenly pump in the specified
amount of grease.
7. Wipe the fittings clean of excess grease.
8. Replace cover “F”, Figure 2.5.
9. Power up the machine. Refer to the
appropriate power-up procedure in Chapter 1.
10. Move the tailstock to the fixed Home position.
11. If necessary, clear the lubrication alarm as
outlined in "Lubrication Alarm", page 2-2.
M-448B 2-5
Figure 2.5 - Grease Manifold Access
Cover on Tailstock
TP5256
F
Figure 2.6 - Tailstock Grease Manifold
TP5223
G