Hardinge Talent 6/45, Руководство по обслуживанию

Страница: 21 / 104

AXIS LUBRICATION
- NOTE -
Grease should be added when the linear guides are still warm from operation.
X AND Z AXIS LUBRICATION ON TALENT
®
6/45 AND 8/52 LATHES
1. Wait for the cycle to end and that the spindles
and slides are stationary.
- NOTE -
Refer to the Operator’s Manual
(M-447) for information on using Rapid
Reference to move axes to the refer-
ence position.
2. Move the Z axis to the reference position.
3. Power down and lock out the machine. Refer to
the appropriate power-down procedure in
Chapter 1.
4. Remove cover “A”, Figure 2.1, to gain access
to the fittings on grease manifolds “B” and “C”,
Figure 2.2.
5. Clean the grease fittings.
- NOTE -
Only use a manually operated grease
gun.
Manifold “B” supplies grease to the X
axis. Manifold “C” supplies grease to
the Z axis.
6. Attach the grease gun nozzle to each grease
fitting; slowly and evenly pump in the specified
amount of grease.
7. Wipe the fittings clean of excess grease.
8. Install cover “A”, Figure 2.1.
9. Power up the machine. Refer to the
appropriate power-up procedure in Chapter 1.
10. If necessary, clear the lubrication alarm as
outlined in "Lubrication Alarm", page 2-2.
11. Jog the axes at 50% of the maximum rapid
traverse for a full 30 minutes before resuming
automatic machine operation.
M-448B 2-3
Figure 2.1 - Rear Access Cover
TP5196
A
Figure 2.2 - Grease Manifolds
TP5038
B
C