Hardi NAVIGATOR VPZ, Инструкция

Страница: 105 / 204

5 - Operation
105
1.
Remove the cap and connect a suction hose to the suction
manifold.
2.
Turn the pressure SmartValve to MainTank.
3.
Turn the suction SmartValve to “External Filling Device”.
4.
Close the agitation valve.
÷
NOTE! If AutoFill is available, the amount of water to be filled can
be setup before proceeding with step 5.
5.
Activate External Filling Device by turning the handle above the
suction manifold to open position.
6.
Engage the pump and set PTO revolutions at max. 540 RPM or
1000 RPM depending on pump model.
7.
The tank is now filled with water. Keep an eye on the liquid level
indicator.
8.
Turn the handle above the suction manifold away from “External
Filling Device” to discontinue the filling process. Now disengage
the pump.
9.
Disconnect the suction hose and replace the cap.
€
DANGER! Prevent contamination or injury. Do not open the
suction valve for the External Filling Device, unless the pump is
running and the filling hose is connected. If this valve is opened
without the pump running, liquid will stream out of the coupler.
±
WARNING! Do not leave the sprayer while filling the tank, and
keep an eye on the level indicator in order NOT to overfill the
tank.
±
WARNING! If suction hose/filter is carried on the sprayer during
spraying, it can be contaminated by spray drift which will be transferred to lake/river when filling!
μ
ATTENTION! Observe local legislation regarding use of filling device. In some areas, it is prohibited to fill from open
water reservoirs (lakes, rivers etc.). It is strongly recommended only to fill from closed reservoirs (mobile water tanks
etc.) to prevent contamination.