Hardi MEGA VPZ NK, Оригинальная инструкция

Страница: 116 / 178

5 - Operation
116
±
WARNING! It is the responsibility of the sprayer operator or owner, that the sprayer is cleaned sufficiently to prevent
contamination of the environment, crop damages and health and safety hazards to the operator and the public.
HARDI cannot be held responsible for any damages or incidents related to insufficient cleaning.
˜
ATTENTION! The rinsing nozzles cannot always guarantee a 100% cleaning of the tank. Clean manually with a high
pressure cleaner afterwards, especially if the next crop is sensitive to the chemical just sprayed!
Using the Drain Valve
The drain valve is operated from the right side of the sprayer’s frontthe
ladder and is located just beside the main tank lid.
1.
Pull the string to open the drain valve.
2.
The valve is spring-loaded, but can be kept open by pulling the
string upwards in the V-shaped slit.
3.
To release, pull the string downward and the valve will close
automatically.
If draining residues, e.g. liquid fertilizer into a reservoir, a snap coupler
with hose can rapidly be connected to the drain valve, and the liquid is
safely drained.
Pressure Draining
It is possible to drain to an external tank. This is done the following way:
1.
Connect a hose from an external tank to the quick coupler on the
sprayer.
2.
Turn the pressure valve towards .
3.
Turn the suction valve towards .
4.
Engage the PTO to start the pump.
5.
When the tank is drained, then turn off the PTO again.
6.
Disconnect the hose and mount the cap for the quick coupler.
€
DANGER! Ensure that the cap for the quick coupler is correctly
mounted on the filling stud in its locked position. Failure to do so
causes a risk of contamination and injury from the quick coupler
cap being “shot” off when pressurized! If it is not possible to
mount the lid completely, lubricate the rubber seal and the grip
hooks and try again.