Hard Head 001-715, Руководство по эксплуатации

Страница: 17 / 17

EN
17
4. Remove the blind and mark out the
attachment points for the blind support.
5. Screw on the blind support with suitable
screws.
6. Fasten the blind support pins in the holes
in the bottom rail.
FIG. 9
USE
ADJUSTING THE SLATS
Use the wand to adjust the vertical position
of the slats by turning the wand clockwise or
anticlockwise.
LIFTING AND LOWERING
1. Make sure that the slats are horizontal
when lifting and lowering.
2. Pull the blind cord to the left to lift or
lower the blind.
3. When the blind has reached the required
height, pull the blind cords to the right to
fix the height.
Line lock
1. Wind all the loose blind cords round the
line lock.
FIG. 10
MAINTENANCE
Clean with a vacuum cleaner or cloth.
Wand
1. Screw in the wand.
FIG. 5
Cord stop
1. Lower down the blind to the required
position and lock in place (see instructions
for lifting and lowering).
2. Measure the distance from the top rail
to the cord stop. If the cord stop comes
25–50 mm below the top rail no further
adjustment is necessary.
3. Adjust the distance by undoing the cord stop
knot and adjusting the cord so that the cord
stop is 25–50 mm below the top rail.
4. Tighten the cord stop knot to fix the cord
stop in the right place.
FIG. 6
Line lock
NOTE:
The line lock must be fixed at least 1.6 m
above the floor.
1. Fit the line lock on the window frame or
wall with suitable screws.
FIG. 7
Line collector
1. Fit the line collector as shown in the
diagram.
FIG. 8
Blind support
Use the blind support if the blind is to be
permanently fixed at a specific height.
1. Fit the blind according to the instructions.
2. Lower down the blind and place the blind
support with the pins fastened in each
end of the bottom rail.
3. Position the blind support in a suitable
place.