EN
16
ASSEMBLY
Fasteners
1. Decide where to put the blind. Make sure
the fasteners are fitted to the blind. Check
that the top rail is horizontal and correctly
positioned sideways.
– Positioning in window recess; Place
the blind so that it does not touch
handles etc.
FIG. 2
– Positioning outside window recess;
Place the blind so that it sticks out
the same on both sides of the
window.
FIG. 3
2. Mark out the positions of the fasteners.
3. Release the fasteners from the blind by
turning the tabs to the right and twisting
loose the top rail.
4. Mark out the screw holes for the fasteners.
Predrill if necessary, and screw on the
fasteners.
– Screw on with small wood screws on
wooden walls. Always predrill in
wood to avoid cracking.
– Use expander screws or the
equivalent on plasterboard walls.
– Special drills and plugs are needed
for stone/brick.
5. Make sure that the blind cords hang in
towards the room and that the flexible
tabs point straight out from the fastener.
6. Twist the top rail firmly into the fasteners.
7. Lock the fastener in the rail by turning the
tabs to the left and press in to lock.
FIG. 4
• Children can be choked if this
safety device is not installed
and adjusted. Read the
instructions carefully and
install accordingly.
• The line collector eliminates
the dangerous loop and is
actuated with a weight of 6
kg or after five seconds in
use. If the line collector has
tripped the parts must be
put together again before
using it again. Make sure the
lines are positioned as
shown in the installation
instructions.
• The installation must be
carried out by persons with
the requisite experience.
DESCRIPTION
1. Wand
2. Top rail
3. Cord stop
4. Blind cord
5. Cord holder
6. Line collector
7. Bottom rail
8. Ceiling/wall bracket
9. Blind support
FIG. 1
Содержание 001-715
Страница 3: ...1 2 4 3 1 2 3 5 4 6 7 8 9 ...
Страница 4: ...5 8 10 9 7 6 ...
