Harbor Freight Tools ZURICH OBD2, Руководство пользователя, Страница: 15 / 36

For technical questions, please call 1-888-866-5797
13
VIEWING ABS DTCs
Using the Scan Tool
VIEWING ABS DTCs
13
„
If the KOEO test was selected, and the vehicle’s engine is
running , an advisory message shows.
- Turn the ignition OFF then back ON and press ENTER to
try again, or, press
SYSTEM MENU
to return to the
System Menu.
4. If the KOER test was selected, an “instructional” message shows.
„
Turn the steering wheel to the left, then release.
„
Press and release the brake pedal.
„
Cycle the overdrive switch (if equipped).
„
A “One moment please” message
displays while the test is in progress.
5. Refer to DISPLAY FUNCTIONS on
page 3 for a description of LCD display
elements.
I/M MONITOR STATUS
icons are not displayed
when viewing enhanced
DTCs.
In the case of long code definitions, a small arrow is
shown in the upper/ lower right-hand corner of the
code display area to indicate the presence of additional
information.
„
If no codes are present, a “System
Pass” displays. Press any Hotkey.
6. If more than one code was retrieved
press
DTC/FF to display additional
codes one at a time.
7. When the last retrieved DTC has been
displayed and
DTC/FF
is pressed, the
Scan Tool returns to the “Priority” code.
„
To view additional enhanced DTCs, repeat steps 1 through 6 ,
above.
„
To exit the enhanced mode, press SYSTEM MENU to return
to the System Menu. Select Global OBD , then press ENTER
to return to the Global OBD2 mode.
VIEWING ABS DTCs
Refer to the manufacturer’s website for vehicle makes covered.
Reading ABS DTCs
1. When ABS is chosen from the System Menu, a "One moment
please" message displays while the Scan Tool retrieves the selected
DTCs.