Page 16
For technical questions, please call 1-888-866-5797.
Item 56825
S
AFET
y
M
AINTENAN
c
E
B
ASI
c W
EL
d
IN
g
W
EL
d
IN
g T
Ip
S
SETUP
TIg Welding
TO pREVENT SERIOUS INJURy ANd dEATH:
do not weld without grounding clamp.
When the operator is not holding the Torch, it must be sitting on a nonconductive, nonflammable surface.
Only hold TIg Rod with an electrically insulated welding glove.
TO pREVENT dEATH FROM ASpHyXIATION:
do not open gas without proper ventilation. Fix gas leaks immediately.
Shielding gas can displace
air and cause rapid loss of consciousness and death.
Shielding gas without carbon dioxide can be
even more hazardous because asphyxiation can start without feeling shortness of breath.
NOTIcE:
TIG welding is a complicated process,
requiring experience and skill to achieve
successful results. Training beyond the scope of
this manual is required to TIG weld properly.
1. Open gas cylinder’s valve all the way.
2. Set Flow Gauge to SCFH value indicated
on Settings Chart on top of Welder.
3. Turn the Power Switch to the OFF position, then
plug the Welder into a properly grounded, GFCI
SURWHFWHG9$&DPSUDWHGRXWOHWRU
9$&UHFHSWDFOHWKDWPDWFKHVWKHSOXJ
The circuit must be equipped with delayed
action-type circuit breaker or fuses.
4. Set TIG Torch down on nonconductive,
nonflammable surface well away
from any grounded objects.
5. Turn the Power Switch ON.
current
Output Knob
Welding
Mode Switch
power
Switch
6.
Select process:
Press Welding Mode
Switch to scroll to desired welding mode.
Ac TIg - For welding aluminum
dc TIg - For welding
mild and stainless steel
dc STIcK - go to Stick
Welding on page 18.
7. Set amperage according to Settings Chart on top
of Welder. Set to high end of amperage range.
For example: Range is 80-100A,
set amperage to 100A.
NOTE:
Amperage settings are
approximate. Adjust as necessary.
Other parameters like AC balance, pre-gas flow
time and post-gas flow time have been preset:
• Pre-Flow: The number of seconds that gas
ZLOOIORZRQFHWKH)RRW3HGDOLVSXVKHG±WKLV
is preset at 0.3 seconds. The arc will not start
for that preset time, but gas will flow. Once
the preset time expires, the arc will start.
• Post-Flow: The number of seconds that gas
will flow once the Foot Pedal is released. This
has been preset and automatically adjusts
based on the preset amperage output.
WARNINg! TO pREVENT SERIOUS INJURy:
protective gear must be worn when using the
Welder; minimum shade number 10 full face shield
RUZHOGLQJPDVNHDUSURWHFWLRQZHOGLQJJORYHV
sleeves and apron, NIOSH-approved respirator,
and fire resistant work clothes without pockets
should be worn when welding. Light from the
arc can cause permanent damage to the eyes
and skin. do not breathe arc fumes.
Содержание TITANIUM TIG200
Страница 33: ...JRXUD 5RDG DODEDVDV...
