SKU 65330
For technical questions, please call 1-800-444-3353.
Page 10
Close the Release Valve on the Air/
l.
Hydraulic Jack.
(See air/Hydraulic
jack Owner’s manual.)
Then squeeze and hold the Lever of
m.
the Air/Hydraulic Jack. This action
will pneumatically lower the Filter
Crushing Head (13).
(See assy.
diagram and air/Hydraulic jack
Owner’s manual.)
Slowly lower the Filter Crushing
n.
Head (13), making sure the Crush-
ing Head can be lowered
into
the
Crushing Housing (14).
(See assy. diagram.)
Raise the Crushing Head (13) all
o.
the way up by opening the Release
Valve on the Air/Hydraulic Jack.
Then place the oil filter that is to be
crushed into the Crushing Housing
(14).
(See assy. diagram and air/
Hydraulic jack Owner’s manual.)
Close the Release Valve on the Air/
p.
Hydraulic Jack.
(See air/Hydraulic
jack Owner’s manual.)
Then squeeze and hold the Lever
q.
of the Air/Hydraulic Jack to lower
the Filter Crushing Head (13).
(See
assy. diagram and air/Hydraulic
jack Owner’s manual.)
Continue lowering the Filter Crush-
r.
ing Head (13) onto the oil filter until
the filter is crushed to within 25% of
its original height.
(See assy. diagram.)
Open the Release Valve on the Air/
s.
Hydraulic Jack. This will allow the
Springs (5) to again raise the Crush-
ing Head (13) so you can remove
the crushed oil filter.
(See assy.
diagram and air/Hydraulic jack
Owner’s manual.)
If you will use the unit as a general
3.
Shop Press
:
To operate the Shop Press as a
a.
general
Press, remove the Crushing
Housing (14) and Crushing Head
(13) from the unit. If necessary, the
Connecting Rod (11) may be re-
moved and the Press Head (9) can
be screwed under the Frame (7)
directly. Follow previous instructions
for the manual and pneumatic op-
eration of the Shop Press.
(See assy. diagram.)
To prevent accidents, turn off the
4.
tool, detach the air supply and safely
discharge any residual air pressure in
the Shop Press.