SKU 65330
For technical questions, please call 1-800-444-3353.
Page 7
With the help of another person,
7.
elevate and position the Air/Hydraulic
Jack (21) to Top Cross Beam (22).
Tighten Set Screw (25) against Ram
top of the Jack. Raise Frame (7) and
tighten Nut (10) to secure the Jack
(21).
(See assy. diagram.)
Tighten all Nuts and Bolts.
8.
If you will use the unit as a com-
9.
mon Press
: Place the Press Plates
(26) on the Working Bed (15). Then
screw the Press Head (9) under the
Frame (7).
(See assy. diagram.)
If you will use the unit as a filter
10.
crusher
: Screw the Filter Crush-
ing Head (13) and Connecting Rod
(11) under the Frame (7). Attach
the Drain Hose (24) to the bottom
outlet of the Crushing Housing (14)
with one Clamp (23). Then place the
Crusher attachment on the Working
Bed (15). NOTE: Make sure the
Drain Hose empties into a proper oil
container.
(See assy. diagram.)
Use a proper lifting device to move
11.
the assembled Shop Press to the
desired work location.
Use the four 1/2” diameter mounting
12.
holes in the Legs (16) as a template
for drilling four 1/2” diameter holes in
the concrete floor surface. Temporar
-
ily remove the Shop Press from its
work location. Then drill the four 1/2”
mounting holes in the concrete.
(See assy. diagram.)
Set the Shop Press back into posi-
13.
tion, and firmly secure the Shop
Press to the concrete floor surface
using appropriate concrete anchors
(not included).
The Shop Press is now ready to use.
14.
air Supply
TO PREVENT
ExPLOSION:
Use only clean, dry, regulated,
compressed air to power this
tool. do not use oxygen,
carbon dioxide, combustible
gases, or any other bottled
gas as a power source for this
tool.
Incorporate shut-off valve, regulator
1.
with pressure gauge, and filter for
best service, as shown in the previ-