OPERATING INSTRUCTIONS
DC VOLTAGE MEASUREMENT
1.
2.
3.
4.
Connect the red test lead to the “V” jack and the black lead to the “COM”
jack.
Set rotary switch at desired 1000V
position.
Connect test leads across the source or load being measured.
Read voltage value on the LCD display along with the polarity of the red
lead connection.
AC VOLTAGE MEASUREMENT
1.
2.
3.
4.
Connect the red test lead to “V” jack and the black test lead to the “COM”
jack.
Set the rotary switch at desired 750V~ position.
Connect test leads across the source or load being measured.
Read voltage value on the LCD display.
AC CURRENT MEASUREMENT
1.
2.
3.
Set the rotary switch at desired A~ position.
Press the trigger to open transformer jaw and to clamp one conductor
only, making sure that the jaw is firmly closed around the conductor.
Read current value on LCD display.
RESISTANCE MEASUREMENT
1.
2.
3.
4.
Connect the red test lead to “
Ω
” jack and black test lead to the “COM” jack.
(The polarity of red lead is positive “+”.)
Set the rotary switch at desired ”
Ω
” range position.
Connect test leads across the resistor to be measured and read LCD
display.
If the resistance being measured is connected to a circuit
turn off power
and discharge all capacitors before applying test probes.
NOTE:
1.
2.
3.
4.
If the resistance being measured exceeds the maximum value of the range
selected or the input is not connected, an overrange indication
OL
will be
displayed.
When checking in-circuit resistance, be sure the circuit under test has all
power removed and that all capacitors have been discharged fully.
For measuring resistance above 1M
Ω
, the meter may take a few seconds
to get stable reading. This is normal for high resistance measurements.
At 2000M
Ω
range display reading is around 10 counts when test leads are
shorted.
These counts have to be subtracted from measuring results. For example,
-6-