If “
”appears on display, it indicates that the battery should be replaced. Use the
following procedure to replacing the battery:
1. Disconnect test leads from any live source, turn the rotary switch to OFF, and
remove the test leads from the input terminals.
2. The battery cover is secured to the bottom case by a screw. Using a screwdriver,
remove the screw from the battery cover and remove the battery cover.
3. Remove battery and replace with a new equivalent 9 volt battery.
4. Replace the battery cover and reinstall the screw.
ACCESSORIES
•
Operator’s instruction manual
•
Set of test leads
•
Gift box
•
9 volt battery. NEDA 1604 6F22 006P type
CAUTION:
Using this appliance in an environment with a strong radiated radio-frequency
electromagnetic field (approximately 3V/m),may influence its measuring accuracy.
The accuracy can be reduced to
±
(12% of r 6 digits).
The Clamp is used only for reading AC amperages between the receptacle and
power cord. The Clamp must be used with a Line Splitter to do this. Line
Splitters can be purchased at an electrical supply outlet.
NOTE:
Line Splitter, Item 92072 is available from Harbor Freight Tools.
-9-