SKU 99621
For technical questions, please call 1-800-444-3353.
Page 4
unPAcking
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
SEt uP inStRuctionS
Read the EntiRE imPoRtAnt
SAFEty inStRuctionS
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
note:
For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Assembly
The ATV Spreader comes partially
1.
assembled.
Mount the two sides of the Frame
2.
Rail (21) to the Hopper Assembly (8)
using Screws M5 x 35 (14).
Position the Gauge Assembly (22)
3.
to either Frame Rail (21) based on
whether the Hopper Assembly (8) is
to be mounted on the front, or rear
rack of the ATV. If mounted on the
rear rack, the Control Handle (25)
should be on the right Frame Rail
(21). If mounted on the front rack,
place the Control Handle (25) on the
Left Frame Rail (21). See
Figure 1
below.
Switch box installation:
WARning:
To prevent serious injury,
make sure the ATV is OFF before install-
ing The Switch Box Assembly (31) .
Attach the Switch Box Assembly (31)
1.
to your ATV. Route cable ties through
the two slots located on the Switch
Box Assembly (31) and connect them
onto the ATV Frame.
notE:
Make sure the Switch Box As-
sembly (31) is secure before proceeding.
Connect the ATV Battery Terminals
2.
(31-3) to battery. Connect the white
wire to the battery’s positive pole,
connect the black wire to the battery’s
negative pole .
Connect the Motor Terminal (31-4) to
3.
the Electric Motor (3) terminal.
Connect the ATV Battery Terminals
4.
(31-3) to the Motor Assembly using
the Harness Connector. See parts list
and assembly diagram page 7 and 8.
REV 08g; 09a
Figure 1
