Page 5
SKU 96933
For technical questions, please call 1-800-444-3353.
Verify that all wires are held securely.
3.
Plug the “Trunk” Connector (23) into the “Trailer” Connector (18).
4.
5.
warning! if the wire Splices (21) are used improperly and damage
the vehicle’s wiring, the vehicles rear lights may fail, resulting in a traffic
hazard. have an assistant operate the vehicle’s lights while you carefully
check that the vehicle lights and the towing lights all work properly after
installation.
If any function of the vehicle or towing lights does not work, do
not drive the vehicle. Carefully inspect the splice connection and the circuit that
failed and repair the problem and retest before use.
Disconnect the “Trailer” Connector (18) if the light kit is not going to be used yet.
6.
Set up
To help avoid scratches, clean the mounting locations and clean the protective
1.
labels under the lights.
Set the lights on the back of the vehicle being towed so that the
2.
RED side of
each light faces backwards. Set the light that has a green wire on the right side
and the light that does not have a green wire on the left side.
Make sure all wires are secured with enough slack to prevent binding when
3.
turning, but controlled enough to prevent roadway or moving part contact.
When routing the wires along the trailer, avoid sharp objects, tight corners and
exposure to the elements. Keep away from moving parts. Secure with cable
ties where necessary and use rubber grommets when passing through cut-outs.
Plug the “Trunk” Connector into the “Trailer” Connector.
4.
5.
warning!
have an assistant operate the vehicle’s lights while you
carefully check that the vehicle lights and the towing lights all work
properly.
Both tow lights should illuminate when the towing vehicle’s running lights are
•
switched on.
The tow lights should both light brightly as you apply the brake.
•
The tow light with a green wire should blink brightly with the right turn signal.
•
The tow light without a green wire should blink brightly with the left turn signal.
•
if anY function of the vehicle lights or towing lights does not work, do
not drive the towing vehicle until all lights are repaired and retested
successfully.
The tow light kit is now ready for use. It will automatically illuminate when turn
6.
and brake pedal or turn signals in the towing vehicle are used.
7.
warning!
check light position and function regularly when towing,
especially on rough or uneven surfaces.
The magnets cannot hold the lights
to the vehicle in extreme circumstances.
