FINAL INSTALLATION
15
Remove hex nut (S) and 11 mm lock washer (T)
from threaded rod on light kit fitter (O). Gently feed
wires from light kit fitter (O) through hole in middle
of switch housing (F) followed by 11 mm lock
washer (T) and hex nut (S). Tighten hex nut (S)
over 11 mm lock washer (T) for a secure fit. (Fig. 5)
Carefully arrange wiring within switch housing (F),
and then align holes in switch housing (F) with
holes in switch housing plate. Attach switch
housing (F) with three switch housing plate screws
(W) that were removed in Step 4 on the previous
page. Tighten all switch housing plate screws (W)
securely. (Fig. 7)
7.
5.
5
7
S
T
O
F
Threaded
Rod
Connect
WHITE
wire from light kit fitter (O) to
WHITE
wire from switch housing (F). Connect
BLACK
wire from light kit fitter (O) to
BLUE
(or
BLACK
) wire from switch housing (F). Make sure
that molex connections snap together securely.
(Fig. 6)
Connect male plug from motor housing (D) to
female plug from switch housing (F), matching up
the colors on the male plug with the colors on the
female plug for correct fit. . Make sure that plugs
are connected tightly. (Fig. 6)
6.
Molex
Connections
Switch
Housing
Plate
F
O
W
6
female
plug
F
D
O
male
plug
