Secure mounting bracket (C) to outlet box using
screws, spring washers, and flat washers provided
with the outlet box. (Fig. 4)
*
NOTE: It is very important that you use the proper
hardware when installing the mounting bracket (C)
as this will support the fan.
IMPORTANT:
If using the angle mount, make sure
open end of mounting bracket (C) is installed
facing the higher point of the ceiling.
4.
FAN MOUNTING
8
1.
INITIAL INSTALLATION
4
Remove pin (L) and clip (M) from motor housing
yoke at top of motor housing (E) and partially
loosen set screws. (Fig. 1)
*
Helpful Hint
: Downrod style mounting is best
suited for ceilings 8 ft. (2.44 m) high or higher. For
taller ceilings you may want to use a longer
downrod (not included) than the one provided.
Angle style mounting is best suited for angled or
vaulted ceilings. A longer downrod is sometimes
necessary to ensure proper blade clearance.
C
Set
Screw
1
L
E
2. Thread wires from motor housing (E) through
downrod (A). Slip downrod (A) into housing
yoke, align holes and re-install pin (L) and clip
(M). Tighten downrod (A) set screws and then
tighten nuts. (Fig. 2)
A
E
2
L
M
M
Set
Screw
