FAN MOUNTING
7. Locate hanging ball (K) and stop pin (DD). Check
inside of hanging ball (K) with finger to be sure
surface is smooth; if it is not, partially loosen set
screw on side of hanging ball (K).
Thread wires from top of downrod (A) through
hanging ball (K) and then slide hanging ball (K)
onto downrod (A)--hanging ball (K) must be turned
with the
rounded
part facing the motor housing
(E). Slide stop pin (DD) through holes at top of
downrod (A),
centering
the stop pin (DD) in the
downrod (K) so equal amounts show on each side
of the downrod (A).
Make sure all three wires
remain on the same side of the stop pin (DD).
(Fig.
7A)
Locate slots inside hanging ball (K), turn hanging
ball (K) so slots align with stop pin (DD) and raise
hanging ball (K) to top of downrod (A). [
NOTE:
It is
extremely important the top of the hanging ball
(K) is flush with the top of the downrod (A)
; the
stop pin (DD) must sit
COMPLETELY
inside of the
slot in the hanging ball (K).] Securely tighten set
screw at top of downrod (A). (Fig. 7B)
10
6. Slide yoke cover (D) onto downrod (A) followed
by wire cage (V), canopy cover (I) and canopy
(B). [
Note:
Canopy cover (I) must be turned with
the shiny side
toward
the motor housing (E).]
(Fig. 6)
B
D
E
I
A
6
V
A
7A
DD
Set Screw
7B
B
K
DD
Set Screw
Slot
A
DD
K
Set
Screw
K
A
Stop Pin x1
Hardware Used
DD
