12
WIRING
Gently slide remote control receiver (S), smooth
side up, into mounting bracket (C). (Fig. 3) Turn
spliced/taped wires upward and gently push wires
and wire connectors (CC) into outlet box. Let
antenna from remote control receiver (S) hang to
the side.
Note:
The remote control included with this fan
meets the following requirements:
a. Not for use with solid state fans.
b. Electrical rating: 120V / 60 Hz; motor
amps:1.5 MAX.;
light watts: 300 (Incandescent only).
Should you choose to use a different remote control
with this fan, it must also meet these same
requirements.
3.
3
Wrap electrical tape (not included) around each
individual wire connector (CC) down to the wire as
shown in Fig. 2.
WARNING
: Make sure no bare wire or wire
strands are visible after making connections. Place
green and white connections on opposite side of
box from the black connections.
E3 Wire Connector x4
2.
Hardware Used
2
CC
CC
CC
CC
1. Make the necessary wiring connections for remote
control operation according to Fig. 1. For each wire
connection, use one of the wire connectors (CC)
provided, making sure to screw wire connector
(CC) on in a clockwise direction. [Make sure to
connect all
GROUND
(
GREEN
) wires together from
fan (on hanging ball (K) and mounting bracket (C))
to
BARE
/
GREEN
wire from ceiling.]
WIRING TIP:
Wiring your fan's remote control
requires extreme patience. Take mandatory breaks
while wiring to allow your arms to rest.
Antenna
C
A
S
K
1
120 V Power
FROM CEILING
BLACK
WHITE
BARE
GREEN
BLACK
WHITE
BLUE
BLUE
BLACK
WHITE
ANTENNA
AC SUPPLY
BLACK
WHITE
C
S
A
