Happy HCS, Инструкция

Страница: 85 / 94

-CS -75
10-6
ERRORS AND WHAT TO DO
10_6 G401
P.FOOT T.CUT
MENU FORWARD
ENT.
P.FOOT T.CUT
MENU FORWARD
ENT.
P.FOOT T.CUT
MENU
FORWARD
ENT.
1
[ERR] Manual
Auto
2
[ERR] Manual
Auto
3
Caution !! main
shaft truns
1. Press the “ENT.” button when showing
[ERR].
2. Press the “Down” arrow button until the
cursor points to “Auto”.
3. Press the “ENT.” button.
The main shaft turns 2 to 3 times and returns to
a stop position (“C” point ) automatically.
The display returns to drive mode.
What to do for “Stop position of main shaft is out of its place (error E-050)”
error E-050
C point
ID:10 Nd: 1
1240
P.FOOT T.CUT
MENU FORWARD
ENT.
1
[ERR] Manual
Auto
1. Press the “ENT.” button when showing
[ERR].
2. Press the “ENT.” button.
The error status is released and the display
shows “drive mode”.
3. Remove the cap over the small hole in the
rear of the machine. Using the 3 mm hex-
agonal driver, Please turn the main shaft
and adjust it to the “C” point.
error E-050
C point
FORWARD
P.FOOT T.CUT
MENU
ENT.
ID:10 Nd: 1
1240
G
2
3
C
When you cannot clear by the method above (Auto)
G