Happy HCS, Инструкция

Страница: 81 / 94

-CS -71
10-2
SPECIFICATIONS • MAINTENANCE
10_2 G401
Cleaning of the rotary hook
If the rotary hook is clogged with waste thread
or dust, it will degrade the stitch quality of the
embroidery or may cause other problems.
For a long sewing life, please keep the rotary
hook clean.
Use the included brush for cleaning the hook.
Cleaning the thread cutting knife
If the thread cutting knife is clogged with waste
thread or dust, the knife will not work correctly.
Please keep the thread cutting knife and device
clean.
1. Remove set screw (2 pieces) by offset
driver and remove the needle plate.
2. Turn the main shaft toward the arrow mark
until the gauge points to the "C" point by
using the 3 mm hexagonal driver.
3. Insert manual lever and pull down the
manual lever that is in the left hand side of
the machine as you face it.
4. Keep pressing the manual lever and turn
the main shaft toward the arrow mark until it
points to the "L" point.
5. Remove any waste thread and dust from
the thread cutting knife and surrounding
area.
6. Adjust the main shaft until the gauge points
to the "C" point.
Thread cutting knife returns to the original
position.
7. Remove manual lever and put the needle
plate back on the bed and attach it with the
screws (2 pieces).
Please do not keep manual lever to knob.
Please take care of manual lever.
CAUTION: To prevent accidents.
When taking care of the machine, be sure to remove the plug.
C
1 2
4
CAUTION: To avoid problems.
Never press the manual lever while
the machine is running.
L
3