17
network gas and tighten the loose joint.
4. lf leak persists contact an authorized agent.
INSTALLATION
The log set and crushed lava rock are shipped together on applicable models. Remove the log
set and un-pack all components. Check for damage caused by freight / transport. DO NOT
install damaged components. The logs are fragile use care when handling.
Place the built-in gas fire burner kit on a level/secure surface in a desired location. The location
must be adjacent to the gas supply cylinder.
NOTE
: Minimum clearances: 1 meter away from the appliance to combustible construction must
be maintained.
You must have clear and easy access to the on/off valve AFTER the appliance is installed and
connected to the gas supply in order to safely turn of the burner.
THE ON/OFF VALVE IS USED TO TURN THE BURNER ON AND OFF.
1.
Cylinder should be positioned on a flat level surface near the built-in gas fire burner kit, but
within the pre-described safe distance 1 meter away.
2.
Make sure the tank valve is in its full off position.
3.
Never attempt to use damaged or plugged equipment. See your local LP Gas Dealer for
repairs.
4.
Connect and tighten the end to the gas regulator with the clip.
5.
When connecting regulator assembly to the tank valve, hand tighten it to a positive stop.
6.
Locate the hose out of the pathways where people may trip over it or in areas where the
hose may be subjected to accidental damage.
7.
Open tank valve fully. Turn the on/off valve at the unit to the ‘off’ position to pressurize the
hose assembly. Use a soapy water solution to check all the connections between the gas
tank connection and the gas valve at the back of the control panel for leaks before
attempting to light the appliance. If a leak is found, turn the tank valve off and do not use the
appliance until repairs can be made. Note that the unit must be turned upside-down to
perform this examination. It is also important to remove battery from igniter before performing
any leak testing by unscrewing the push-button knob at the control panel. Perform leak test
in a well ventilated area outside and where no source of spark can occur.
8.
If everything is secure and leak free to this point you are ready to light your built-in gas fire
burner kit. Read OPERATION instructions.
OPERATION
Upon completing the gas line connection, a small amount of air will be in the lines. When the first
lighting the burner, it will take a few seconds for the lines to purge themselves of this air.
Once the purging is complete, the burner will light and operate as indicated in the instruction
manual. Subsequent lighting of the appliance will not require such a purging unless the gas
supply has been disconnected.
WARNING:
Read and follow the safety and lighting instruction page in this manual and on the
labels on the appliance.
BY NOT FOLLOWING INSTRUCTIONS, A FIRE/ EXPLOSION MAY RESULT. YOU MAY BE
SERIOUSLY INJURED.
BASIC SET UP
Содержание SR2201BI/I2 Plus
Страница 7: ...6 SR2201BI I2 SR4001BIS I2 series exploded...
Страница 8: ...7 SRR2201BI I2 SR4001BIR I2 series exploded...
Страница 12: ...11 SR4001BIS I2 SR4001BIR I2...
