Happy Cocooning SR2201BI/I2 Plus, Инструкция по сборке и руководство по безопасности

Страница: 19 / 20

18
Once the built-in gas fire burner kit is in position, level and safely hooked up to the proper fuel
supply, it is now time to install the crushed lava rock. This is also an essential part of the overall
set-up as it will impact the way the unit burns if not properly installed.
Layer the lava rock in level across the burner bowl. Do not completely cover burner element or
block the igniter box with lava rock. Next, install the imitation fire logs. These should be laid in as
shown in the image above. Start by laying one log in the centre of the unit. This log should be
perpendicular to the igniter box and lay on top of the centre support bracket. Lay the other logs
in a teepee configuration over the first log. It is important that the logs not lay directly on top of
the burner. By blocking the burner it will impact air flow and will cause the unit to be difficult to
ignite or will impact how the flame comes through and burns. Once all the logs are in place as
shown you can begin next steps.
NOTE: Be sure unit is cool before touching any of the
components.
FOR YOUR SAFTY READ BEFORE LIGHTING
A. Before operating smell all around the appliance area for gas odors and next to the floor
because some gases are heavier then air and will settle on the floor.
B. Use only your hand to turn the manual gas control valve. Never use tools. If the valve will not
turn by hand, do not try to repair it. Call a qualified service technician. Force or attempted
repair may result in a fire or explosion,
C. Do not use this appliance if any part has been under water. Immediately call a qualified
service technician to water.
WHAT TO DO IF YOU SMELL GAS
Turn off the gas supply at the cylinder or main shut off valve of city network gas.
⚫
Do not try to light any appliance.
⚫
Do not touch any electric switch; do not use any phone in your building.
⚫
Immediately call your gas supplier from a neighbor
’s phone. Follow the gas supplier’s
instructions.
⚫
If you cannot reach your gas supplier, call the fire department.
LIGHTING INSTRUCTIONS
1.
Remove lid and locate the manual gas control valve and igniter button on the built-in gas fire
burner kit.
2.
Make sure fuel supply is properly connected and turned on at the source / tank.
3.
Depress igniter button until you hear it sparking. You will hear a small popping noise. If you
do not hear the igniter sparking you may need to replace the battery. Replace with a
standard AAA battery, directly behind the rubber push button knob, (unscrew knob to access
battery). Keep igniter button pushed in while pushing then turning the fuel flow valve to the
position of ON/Low flow position at the built-in gas fire burner kit. The jet pilot fire should light
the burner within 15 seconds; after the burner lit, release the igniter button but still keep
pushing the fuel flow valve for 20 seconds to allow the thermocouple to function. After the 20
seconds, release the fuel flow valve; if the burner keeps lit, you can adjust the flame to the
position of HI. However, if the flame extincts after the fuel flow valve released, Re-try and
start from Step-1 again after 5 minutes.
TO TURN OFF GAS
Turn the ON/OFF valve to the off
“ ”position at the unit, then turn the valve on the LP tank, or
the main shut off valve of natural gas system, to the OFF position.