EN
Haojue HJ125-8 99011H30220H000 V02 EN+FR 2015-3-2
(41)
B
CAUTION
Carefully inspect whether the engine parts that
have been dismantled and installed again suffer
any oil leakage.
B
CAUTION
It is suggested to replace the seal rings when the
engine oil filter element is replaced.
CLUTCH
Method to inspect the clutch cable gap
4
: remove the
rubber bush
1
along the clutch cable, operate the clutch
handle and make sure there is a gap of 4mm before there
is an apparent resistance. If the gap is insufficient, adjust
it with the method below.
1. Remove the rubber bush
1
along the clutch cable,
loosen the nut
2
.
2. Turn the adjusting screw
3
clockwise till the end.
3. Loosen the lock nut
5
, adjust the nut
6
along
the front-back direction, operate the clutch lever and
adjust the clutch cable gap
4
to be about 4mm.
4. Do fine adjustment through the adjusting screw
3
.
5. Firmly lock the nut
2
and
5
, and then mount the
rubber bushes
1
.
B
CAUTION
Excessive clutch cable play can easily result in
wear and faults in the clutch and the gear shift
lever. If the clutch cable gap is not correct, or the
clutch is slipping or accelerating weakly, adjust the
cable on time.
CARBURETOR
Stable carbureting evaporation is the most fundamental
requirement for the carburetor.
The carbureting
evaporation has been accurately set in the factory. Please
do not change its setup. You only need to pay attention to
two things: idle and throttle cable free-play.
Adjustment of idle speed
1. Start the engine, keep it running
at idle till fully pre-heated.
2. After the engine has been pre-
heated, release the throttle, turn
the adjusting screw to right and
left to keep the engine revolving speed between 1300–
1500 rpm.
39
Haojue HJ125-8 99011H30220H000 V02 EN+FR 2015-3-2
(41)