(48)
Haojue HJ110-5 99011H53150H000 V01 EN 2016-5-27
Tires
•
Inflate the tires to the pressure recommended in this
manual.
Exterior
•
Spray all rubber parts with a rubber protective agent.
•
Spray all paint-free surfaces with an anti-rust agent.
•
Coat the paint surface with vehicle wax.
Procedures for motorcycle re-service
•
Clean the motorcycle completely.
•
Re-install the battery.
NOTE: Connect the wire to the positive terminal first; then
the negative terminal.
•
Remove the spark plug.
Start the engine several
times, and then mount the spark plug.
•
Adjust tire pressure according to the instructions in the
tire section.
•
Lubricate
according
to
the
instructions
in
the
lubrication section.
•
Be sure to conduct necessary inspections according
to this manual before riding.
NOTICE OF BATTERY USAGE
1. ACTIVATION OF NEW BATTERY
1.1 Adding electrolyte
1.1.1 Check outer appearance of battery. Make sure that
there is no bruise or cracks on the outer case and there is
no distortion or deformation of terminals.
1.1.2 Place the battery on a level position, remove the
sealing tape and place filling filter at the battery electrolyte
inlet.
1.1.3 Take out the battery electrolyte supplied with the
battery, remove the sealing plug, place the electrolyte
bottle upside down with the filling outlets aligned with
inlets of the funnel; if this battery don’t equip the funnel
there, place the electrolyte bottle upside down with the
filling outlets aligned with inlets of the battery, press it
down with force to prick the film for filling. Check if there
are air bubbles at each filling inlet. If there are no bubbles,
pat the bottom of electrolyte bottle twice or 3 times.
1.1.4 At the completion of electrolyte filling, slowly take out
electrolyte bottle (and funnel).
1.1.5 Align the sealing plugs with the filling inlets of battery,
press them in with force until the sealing cap and battery
top form a plane. Wash away electrolyte outside battery
with clean water and dry it with a cloth.
1.1.6 30 minutes after battery filling, it can be fitted for
starting. If possible, it is better to charge it for 3–5 hours to
improve starting performance and to prolong service life.
At a very low temperature in winter or after a long period
(48)
Haojue HJ110-5 99011H53150H000 V01 EN 2016-5-27
47