Haojue HJ110-2, Руководство по обслуживанию

Страница: 7 / 170

G E N E R A L I N F O R M AT I O N
1
2
SERIAL NUMBER LOCATIONS
The V.I.N (Vehicle Identification Number) is
stamped on the chassis rear under the saddle.
The engine serial number
is located on the
lower of the left crankcase.
①
②
These numbers are required especially for
registering the motorcycle and ordering the spare
parts.
ENGINE OIL
SAE
20W/50
10W/50
10W/30
20W
10W
40
30
C
F
-20
-4
-10
14
0
32
10
50
20
68
30
86
40
104
Temp.
BREAK-IN PROCEDURE
During the manufacture only the best ossible
are used and all machined parts are
finished to a very high standard
allow the moving part to “BREAK-IN”
s u b j e c t i n g t h e e n g i n e t o m a x i m u m
stresses
s the care and restraint
exercised during its early life The general rules
are as follows:
p
materials
, it is still
necessary to
b e f o r e
. The future performance and reliability
of the engine depend on
.
●
●
●
1 - 2
The break-in mileage is 500 km.
The throttle must not be opened to the full during
the new motorcycle's break-in period. Throttle
opening should be limited to 3/4 of its maximum,
while violent acceleration should be avoided.
Do not maintain constant engine speed for an
extended time period during any portion of the
break-in. Try to vary the throttle position.
≦
FUEL AND OIL
RECOMMENDATIONS
FUEL
Use fuel with an octane number of 90-97
(Research method), preferably unleaded.
NOTE:
Unleaded fuel will extend spark plug life.
Be sure that the motorcycle engine oil you use
comes under API classification of SF or SG and its
viscosity rating is SAE 10W-40. If SAE 10W-40
engine oil is not available, select the oil viscosity
according to the following chart:
https://www.motomanuals.net/