Haojue HJ110-2, Руководство по обслуживанию

Страница: 6 / 170

WARNING
G E N E R A L I N F O R M AT I O N
WARNING/CAUTION/NOTE
Please read this manual and follow its instructions carefully. To emphasize special information, the symbol and the
words WARNING,CAUTION and NOTE have special meanings. Pay special attention to the messages highlighted by
these signal words.
Personal safety of the rider is involved, and disregard of the information could result in injury.
For the protection of the motorcycle, the instructions and rule must be highly strictly adhered to.
NOTE:
Advice to facilitate the repair of the motorcycle is given under this heading. caIculate
Please note, however, that the contained in this manual cannot possibly cover all
potential hazards relating to the servicing, or lack of servicing of the motorcycle. In addition to the WARNING and
CAUTION stated, you must use good judgment and basic mechanical safety principles. If you are unsure about how to
perform a particular service operation, ask a more experienced mechanic for advice.
WARNINGS and CAUTIONS
GENERAL PRECAUTION
●
●
Proper service and repair procedures are important for the safety of the servicing mechanic, the safety and the
reliability of the motorcycle.
When 2 or more persons perform work in cooperation, pay attention to safety of each other.
When it is necessary to run the engine indoors, make sure that exhaust gas is forced outdoor.
When working with toxic or flammable materials, make sure that the area you work in is well-ventilated and that
you follow all of the material manufacturer's instructions.
Never use fuel as a cleaning solvent.
To avoid getting burned, do not touch the engine, engine oil and muffler until they have cooled.
After servicing the fuel, oil, muffler or brake system, check all hoses and fittings related to the system for leaks.
●
●
●
●
●
●
If parts replacement is necessary, replace the parts with the HAOJUE GENUINE PARTs or their equivalent.
When removing parts that are to be reused, keep them arranged in an orderly manner so that they may be
reinstalled in the proper order and orientation.
Be sure to use special tools when instructed.
Make sure that all parts used in reassembly are clean. Lubricate them when specified.
lubricant, bond, or sealant.
When performing service to electrical parts, if the service procedures not required to use the battery power,
disconnect the positive pole.
When removing the battery, disconnect the negative wire first and then the positive wire.
When reconnecting the battery, connect the positive wire first and then the negative wire, and place the pole
cover on the positive pole.
ightening cylinder head and crankcase bolts and nuts, tighten the larger sizes first.
Always tighten the bolts and nuts diagonally from the inside working out.
Whenever you remove oil seals, gaskets, packing, O-rings, lock washers, cotter pins, circlips, and certain
other parts as specified, be sure to replace them with the new ones. Also, before installing these new parts, be
sure to remove any left over material from the mating surfaces.
Never reuse a circlip. When installing a new circlip, take care not to expend the end gap larger than required to
slip the circlip over the shaft. After installing a circlip, always ensure that it is completely seated in its groove and
securely fitted.
Do not use self-lock nuts a few times over.
Use a torque wrench to tighten fasteners to the specified torque, and wipe off grease or oil if a thread is
with them.
After reassembly, check parts for tightness and proper operation.
●
●
●
●
●
●
●
●
●
●
●
●
Use the specified
When t
smeared
NOTE:
●
●
To protect environment, do not unlawfully dispose of used engine oil and other fluids, batteries and tires.
To protect Earth's natural resources, properly dispose of the used motorcycle and parts.
1 - 1
CAUTION
WARNING
CAUTION
https://www.motomanuals.net/