Hanwha Vision TNV-C7013RC, Руководство пользователя

Страница: 9 / 30

English _
9
!
OVER
VIEW
Components (Camera body)
a
b
c
e
f
d
g h
Item Description
a
Network Port
Used to connect the PoE or Ethernet cable for network connection.
b
Audio/Alarm cable port
Port to connect audio and alarm cables.
ALARM #1
They are configurable from the web viewer and can be
used as Alarm in or Alarm out.
ALARM #2
GND
The common “earthing” terminal for connecting Alarm I/
O signals.
MIC A terminal for connecting to an external microphone.
SPEAKER A terminal for connecting to an external speaker.
c
Power port (DC 12 V)
Port for power terminal block.
d
Microphone hole Microphone is embedded.
Item Description
e Micro SD card slot
Compartment for the Micro SD card.
f
Reset Button
The button restores all camera settings to the factory default.
Press and hold for about 5 seconds to reboot the system.
J
If you reset the camera, the network settings will be adjusted so that DHCP can be
enabled. If there is no DHCP server in the network, you must run the Device Manager
program to change the basic network settings such as IP address, Subnet mask,
Gateway, etc., before you can connect to the network.
g Illumination Sensor
The sensor detects incoming light and controls the IR LEDs (in Auto mode).
h
IR LED
These infrared LED’s are controlled by the illumination sensor.
The IR LEDs emit light in the 940nm wavelength range, so red light is invisible to the
human eye.