Hanwha Vision TNV-C7013RC, Руководство пользователя

Страница: 19 / 30

English _
19
!
INST
ALLA
TION & CONNECTION
Power Supply
Use the screwdriver to connect each line (+, –) of the power cable to the corresponding power port of the
camera.
J ` If the power source for PoE and DC 12V are simultaneously turned on, the device power will be supplied by DC 12V.
- You can also use a router featuring PoE to supply power to the camera.
-
Use PoE that is compliant with the IEEE 802.3af protocols.
`
Be careful not to reverse the polarity when you connect the power cable.
`
If you want to connect an external device, you must turn off the external device before proceeding.
Power Cable Specification
Wire Type (AWG) Cable Length (Max.)
DC 12V
#18 19 m
#16 30 m
Network Cable Specification
Item Contents Remark
Connector RJ45 (10/100/1000BASE-T)
Ethernet 10/100/1000BASE-T
Cable UTP Category 5e
Max Distance 100 m
PoE Support IEEE 802.3af
Connecting audio and alarm I/O
Network
Speaker
Microphone
Speaker
Microphone
1. Connect the MIC port of the camera with the microphone or LINE OUT port of the amplifier that the
microphone is connected to.
M
` You can use the internal microphone of the camera without an external microphone connection.
2. Connect the SPEAKER port of the camera with the speaker or LINE IN port of the amplifier that the
speaker is connected to.
3. Check the specifications for audio input.
~ Audio Codec
- Audio In : G.711 PCM (Bit Rate: 64kbps / Sampling Frequency: 8kHz), G.726 ADPCM (Bit Rate:
16Kbps, 24Kbps, 32Kbps, 40Kbps / Sampling Frequency: 8kHz), AAC (Bit Rate: 48Kbps / Sampling
Frequency: 16kHz)
- Audio Out : G.711 PCM (Bit Rate: 64kbps / Sampling Frequency: 8kHz)
~
Full duplex Audio
~ Audio in : Selectable (microphone/Line-in/Internal microphone), Supported voltage: 2.5VDC (4mA), Input
impedance: 2kΩ
~ Audio out
: Line-out (3.5mm mono jack), Maximum output: 1Vms, Line out impedance : 600Ω