Hanter® Wireless Intelligent Alarm Systems - Model HM2088
4.2 Optional Accessories
4.2.1 Wireless Smoke Detector
The Wireless Smoke Detector is widely used in professional security &
protection alarm system. It will send RF signal to the Control Panel when it
detects smoke. It is recommended to locate this unit at a less or non-smoke
area.
4.2.2 Wireless Gas Leak Detector
The Wireless Gas Leak Detector is widely used in professional security &
protection alarm system. It will send RF signal to the Control Panel when it
detects natural gas, piping coal gas and liquefied petroleum gas etc.
4.2.3 Wireless Glass Break Detector
The Glass Break Detector delivers effective coverage in the presence of plate,
tampered, and laminated glass, with easy sensitivity adjustment. The optimal
performance is dependent on the secured and vibration-free mountings. The
Glass Break Detector can be used in most protected areas, including glass
display panel and rooms with blinds, curtains, or multiple windows, as long as
careful coverage tests are conducted.
4.24
Wireless Door Chime
The Wireless Door Chime is ideal to be installed outside the entrance area.
The visitor can notify the premise owner by pressing the button.
Part 5 – System Settings and Operations
5.1 System Settings
(all functions setting under disarming status)
5.1.1 Programming Telephone Numbers
(maximum 4 sets of numbers)
Press the “
” key of the Keychain Remote Control to enter disarming status,
then press “*” key on the Control Panel, input the designated telephone
numbers follow by input *1#, repeat same process for the 2
nd
set preset number
and end with *2#. The rest are the same except for signing off with *3# and
*4# respectively after each entry. *1# is memory No 1, *2# is memory No 2
and so on.
Note: With the completing program the 4 set of numbers will maximize the duration
of Alarm Buzzing to approximately 5 minutes
.
a.
To Program Telephone Number
Example: To set 12345678 as 1
st
set of Telephone Number.
Step 1: Press the “ ” key of the Keychain Remote Control
Step 2: Press “*” key on the Control Panel
Step 3: Press 12345678*1# on the Control Panel
Step 4: The control Panel will emit “Ding Dong” sound to confirm
successfully programmed.
Step 5: Repeat the same steps for the balances 2
nd
, 3
rd
& 4
th
set of Telephone
numbers.
P. 7
Hanter® Wireless Intelligent Alarm Systems - Model HM2088
Part6 -
System Installation and Testing
6.1 Control Panel
The Control Panel can be placed or installed on a desk or the wall (preferably a
hidden spot but easily accessible)
Step 1: Connect the AC adapter.
Insert the adapter jack
to the “9V 300mA” port of
the Control Panel. Then plug the AC adapter into an electrical source.
Step 2: Connect an incoming Telephone line to “Line in” port, Grey line to desktop
telephone set and white line to incoming line connector.
Step 3: Insert the Siren jack into the “Siren” port.
Reminder: In order to make the alarm system operates properly, all the above cables must
be well connected
.
Zone Connector:
The Zone Connector is the connection port to connect wired detectors. It comes with
two group of wire:
Group 1 : Yellow wire & blue wire
Group 2 : white wire & red wire
It can be connect to 2 sets of detectors and using short circuit to trigger alarm. The
blue and red wire link to ground whereby the Yellow wire and white wire are
connected to Detectors.
P. 14