Hanseatic WQP8-7710D, Руководство пользователя

Страница: 64 / 76

Page EN-26 Mounting the front panel
(Not required for substructure model)
You can mount a front panel on the dishwash-
er door which matches your kitchen. The front
panel must not exceed a weight of 5 kg.
1. Hold the front panel against the dish-
washer door such that the lower side of
the front panel is flush with the adjoining
kitchen cupboards.
2. Measure the distance between the front
panel and the control panel.
(g)
3. A gap of 5 mm to 25 mm can be offset
with the 5 mouldings supplied (g). Re-
move the required number of moulding
from the block. To do so, move the mould-
ing vigorously but without using tools.
4. If you only need one moulding, saw off
the four feet that stick out,
clamp the moulding under
the control panel and secure
it using both countersunk
screws (l).
Continue with Step 7.
5. If you need more than one moulding, turn
the lower moulding and push it onto the
other mouldings. This hides the feet and
makes the surfaces flat.
6. If you
– need two mouldings, secure these using
both countersunk screws (l).
– need three mouldings, secure these us-
ing both countersunk screws (m).
– need four to five mouldings, secure
these using both countersunk screws
(n).
(h)
7. Pull apart the two pairs of velcro
straps (h).
8. Remove the protective film from the same
type of velcro strap.
(h)
(h)
9. With the protective film removed, stick
the velcro straps (h) onto the middle of
the recessed areas on the dishwasher
door.
10. Cut the positions of the velcro straps out
of the drilling template.
11. Cut the number of mouldings used off
the drilling template.
Mounting the front panel