Hanseatic HSBS17990WEHEBK, Руководство пользователя

Страница: 88 / 96

Start-up Page EN-40
Disconnecting the hoses
1. Remove the safety clip (51).
2. To do this, push the connector ring on the
hose coupling (42) on or (58) in the direc-
tion of the hose coupling using a small
slot screwdriver while pulling off the hose
coupling.
Extending the appliance hose
You will need these parts to extend the white
appliance hose (56):
(51) 1× Safety clip
(57)
1× Extension hose,
blue, 6 m
(56) (57)
(55) (58)
1. Remove the cap (55) from the white
appliance hose (56) and insert the end
of the appliance hose into the hose cou-
pling (58) on the extension hose (57) until
it makes contact.
(51)
2. Fix the extension hose in place using a
safety clip (51).
3. Close the water filter (43) as described in
section “Connecting the appliance to the
water supply” on page EN-40. Follow steps
3 to 5. Instead of using the white appli-
ance hose, now use the blue extension
hose.
Connecting the appliance to
the water supply
NOTICE
Risk of water damage!
Faulty assembly of the water connec-
tion can result in water damage.
■
The appliance’s water pressure is set
at 2–7 bar. For higher water pressure,
a pressure regulator needs to be in-
stalled. If in doubt, enquire about the
water pressure with the water supply
company.
■
Do not connect the appliance to the
tap or mixing arm of a water heat-
er (e.g. continuous flow heater, pres-
sure-free boiler, etc.).
■
Ensure that the hoses are not kinked
and are carefully connected.
■
Do not extend the inlet hose included
with the delivery if it is too short. In
this case, contact our service depart-
ment (see page EN-45).
■
Do not use old or previously installed
hoses.
You will require a valve with a ¾-inch screw
connector for the water supply.
1. Make sure that the water supply is closed.
(53)
(54)
(51)
2. Push the inlet hose (54) into the ¾-inch
screw connector (53) and affix the inlet
hose with a safety clip (51).